Review identity Secure Score, custom detections, and hunting every week
Microsoft’s weekly guide calls for reviewing Secure Score recommendations, responding to emerging threats with custom detections, and proactive threat hunting.
Read the playbookDSE security knowledge hubCybersecurity
Cybersecurity
Knowledge
Page 147 of the DSE Cybersecurity knowledge center, with source-backed guidance and practical next steps.
DSE-authoredOfficial sourcesReviewed guidance
Search the library Explore this topic
Start with the cornerstone guide Cybersecurity knowledge center
Source-backed guidance for identity, vulnerability reduction, ransomware readiness, detection, response, and recovery.
DSE post stream
1,892 articlesCybersecurity
Turn walking-surface inspections into tracked facility repairs
Under 29 CFR 1910, the rule requires that the employer ensure hazardous conditions on walking-working surfaces are corrected or repaired before an employee uses the walking-working surface again.
Read the briefing
Validate exit-route capacity and permanence before occupancy changes
Under 29 CFR 1910, the rule requires that more than two exit routes be available in a workplace if the number of employees, the size of the building, its occupancy, or the arrangement of the workplace is such that all employees would not be able to evacuate safely during an emergency.
Read the checklist
Make the fire-prevention plan name hazards, controls, and owners
Under 29 CFR 1910, the rule requires that a fire prevention plan include the name or job title of employees responsible for maintaining equipment to prevent or control sources of ignition or fires.
Read the explainer
Map industrial ventilation controls to the operation they actually cover
Under 29 CFR 1910, the rule requires that cradle grinding and polishing operations be performed within a partial enclosure similar to figure G-5.
Read the guide
Control compressed-gas acceptance, storage, and handling as one process
Under 29 CFR 1910, the in-plant handling, storage, and utilization of all compressed gases in cylinders, portable tanks, rail tankcars, or motor vehicle cargo tanks must be in accordance with Compressed Gas Association Pamphlet P-1-1965, which is incorporated by reference as specified in section 1910.6.
Read the playbook
Reconcile flammable-liquid storage rooms, cabinets, and transfer points
Under 29 CFR 1910, equipment used to transfer Category 1 or 2 liquids, or Category 3 liquids flashing below 100 degrees F, between storage tanks and a loading rack may not also transfer Category 3 liquids flashing at or above 100 degrees F or Category 4 liquids.
Read the briefing
Inspect LPG installations as systems, not isolated tanks
Under 29 CFR 1910, the filling connection and the vent from the liquid level gages in containers, filled at point of installation, must not be less than 10 feet in any direction from air openings into sealed combustion system appliances or mechanical ventilation air intakes.
Read the checklist
Use process-safety information to drive facility continuity decisions
Under 29 CFR 1910, subject to the rules and procedures set forth in 29 CFR 1910.1200(i)(1) through 1910.1200(i)(12), employees and their designated representatives must have access to trade secret information contained within the process hazard analysis and other documents required to be developed by this standard.
Read the explainer
Preplan hazardous-substance emergency response by role and hazard
Under 29 CFR 1910, hazardous materials technicians must have received at least 24 hours of training equal to the first responder operations level and in addition have competency in the following areas and the employer must so certify: be able to function within an assigned role in the Incident Command System.
Read the guide