DSE security knowledge hub

Business Continuity
Knowledge

Page 7 of the DSE Business Continuity knowledge center, with source-backed guidance and practical next steps.

DSE-authoredOfficial sourcesReviewed guidance
Search the library
Explore this topic

Business Continuity knowledge center

Preparation and recovery guidance that connects technology protection to real service continuity and tested restoration.

Start with the cornerstone guide
DSE post stream

Business Continuity

773 articles
DSE visual briefPhysical security

Keep workplace fire detection operable under OSHA 1910.164: restore after every alarm and cap delays at 30 seconds

OSHA’s fire detection standard requires employers to restore detection systems promptly after each test or alarm, keep spare devices available, have trained people service and clean detectors, protect them from weather and impact, and avoid delaying alarms more than 30 seconds without an emergency action plan.

Published Reviewed 2 min readBy DSE Security Editorial Team
Read the checklist
DSE visual briefPhysical security
PlaybookAdvisoryBusiness Continuity

Protect winter field crews from cold stress and use winter storm watches to move outdoor work

OSHA has no specific cold-work standard, but employers still must protect workers from recognized cold hazards. Its guidance on wind chill, breaks, buddy systems and training, plus Ready.gov’s 12-to-48-hour winter storm watch lead time, gives dispatch a workable plan.

Published Reviewed 2 min readBy DSE Security Editorial Team
Read the playbook
DSE visual briefPhysical security
PlaybookAdvisoryBusiness Continuity

Schedule rooftop, attic and outdoor jobs with NWS HeatRisk and OSHA’s water, rest and shade guidance

OSHA warns that hazardous heat can occur indoors or outdoors in any season and that new workers need time to acclimatize. NWS HeatRisk gives a 0–4 daily forecast of heat-related impact risk that dispatchers can use to move rooftop and attic work, add breaks and check on crews.

Published Reviewed 2 min readBy DSE Security Editorial Team
Read the playbook
DSE visual briefPhysical security

Inspect the aerial lift and the work zone every shift before mounting cameras or antennas at height

OSHA’s aerial lift fact sheet covers the boom and bucket work common in exterior camera and antenna installs: trained operators, a pre-start inspection every shift, a work-zone check, a lanyard tied to the boom or bucket, load limits and a 10-foot clearance from overhead lines.

Published Reviewed 2 min readBy DSE Security Editorial Team
Read the checklist
DSE visual briefPhysical security

Set up and inspect portable ladders the way OSHA 1926.1053 requires before every camera or reader install

OSHA’s construction ladder standard sets concrete rules that low-voltage installers use daily: rails 3 feet above a landing, a one-quarter setback angle, nonconductive rails near energized equipment, no standing on the top step, three-point climbing and tagging defective ladders out of service.

Published Reviewed 2 min readBy DSE Security Editorial Team
Read the checklist
DSE visual briefPhysical security

Write a drone-sighting procedure that separates routine flights from suspicious activity

CISA’s November 2025 guidance says most drone flights near facilities are harmless and lawful, so security staff need a procedure that learns routine activity, watches for specific indicators, documents what it sees and escalates suspected crime to police.

Published Reviewed 2 min readBy DSE Security Editorial Team
Read the playbook
DSE visual briefPhysical security

Give first responders a working access kit and practiced lockdown in an active-assailant plan

CISA’s 2025 active-assailant emergency action plan guide asks organizations to prepare a first-responder access kit with labeled keys or cards and current floor plans, and to set lockdown protocols with working locks on every entrance and alerts everyone can receive.

Published Reviewed 2 min readBy DSE Security Editorial Team
Read the playbook
DSE visual briefPhysical security

Specify intrusion detection by detection, nuisance and false alarm rates, with every link supervised

The DoD’s 2025 electronic security systems criteria define intrusion detection performance by probability of detection, nuisance and false alarm rates and vulnerability to defeat, and require disrupted links between components to be annunciated at once. Those are useful terms for any commercial specification.

Published Reviewed 2 min readBy DSE Security Editorial Team
Read the guide
DSE visual briefContinuity & recovery
PlaybookInformationBusiness ContinuityIT

Upgrade a neglected WordPress site in planned steps: verified backups first, then incremental releases

WordPress’s extended upgrade instructions require a usable backup of the database and every file before a manual upgrade, and suggest upgrading incrementally when crossing more than two major releases. Treat a neglected site as a staged recovery project.

Published Reviewed 2 min readBy DSE Security Editorial Team
Read the playbook
DSE visual briefNetworks & infrastructure

Michigan workplaces answer to MIOSHA: check its differing standards before applying federal OSHA guidance

Michigan runs an OSHA-approved State Plan, MIOSHA, covering most private-sector and state and local government workplaces. Many MIOSHA standards differ from federal OSHA, including fire equipment, electrical hazards and construction telecommunications.

Published Reviewed 2 min readBy DSE Security Editorial Team
Read the explainer